Skip to content
KULAINAAUTOMATION
Menu

Industry

Panels for textile mills

Textile mills run hundreds of motors on spinning, weaving and processing lines in air full of fibre fly. Kulaina builds MCC, APFC and PCC panels for mills, with enclosures that keep fibre out of the switchgear, motor control grouped by line and power factor correction that keeps penalties off the bill.

Risks we design for

  • Fibre fly in the switchgear

    Lint settles on busbars, contactors and drives, traps heat and can start fires. Enclosures need the right IP rating and filtered ventilation.

  • Hundreds of motors across the mill

    Spinning frames, looms and humidification plants each have their own starters and drives. Grouping them by line in MCCs keeps faults contained and maintenance simple.

  • Low power factor from motor loads

    Lightly loaded motors pull power factor down. Without correction, mills pay penalties and run hotter cables and transformers.

Recommended panels

Cleaning is part of the design. We place filters and inspection covers where your maintenance team can reach them, so clearing lint from the panels becomes a routine job rather than a shutdown.

Compliance notes

Frequently asked questions

Which IP rating do panels in a textile mill need?

It depends on the room. Panels on the production floor usually need IP54 or better with filtered ventilation, while panels in a separate electrical room can use a lower rating.

How does power factor correction help a textile mill?

Mills have many lightly loaded motors, which lowers power factor. An APFC panel switches capacitors in and out to keep it near unity, which avoids penalties and reduces losses.

Discuss your panel requirement

Send your single-line diagram, BOQ or tender reference. An engineer replies within one working day.

Have drawings or a tender? Use the full enquiry form.