Skip to content
KULAINAAUTOMATION
Menu

Product

DG synchronisation panels

A DG synchronisation panel matches the voltage, frequency and phase angle of two or more generators so they can run in parallel on one bus. It shares kW and kVAR load between them automatically, which lets you run only the sets you need and keeps essential loads powered if one set trips.

Specifications

DG synchronisation panels specifications
FunctionAutomatic synchronising of two or more DG sets
Load sharingkW and kVAR
Bus sensingDead bus sensing
ControlPLC / HMI based
ProtectionOver/under voltage and frequency, earth fault, reverse power

Options

  • Automatic and manual synchronising modes
  • Integration with AMF logic for mains failure

Where it is used

  • Factories with several DG sets for backup or captive power
  • Hospitals that need generator redundancy
  • Commercial complexes that run part of their load on DG

Standards

IS 8623 · IEC 61439

Reverse power protection is the safeguard most sites never see working. If one set starts to motor, drawing power from the bus instead of supplying it, the panel trips it before the motoring set damages its engine or overloads the sets still generating.

Frequently asked questions

Why run DG sets in parallel?

Parallel sets let you match running capacity to the load, so fewer sets run at light load and each runs nearer its efficient rating. If one set trips, the others carry the essential load.

What is dead bus sensing?

Dead bus sensing checks whether the common bus is live. If it is dead, the panel lets the first generator that is ready close onto it without synchronising and holds the others back until each has synchronised to it. That stops two sets closing onto a dead bus at the same moment, out of phase.

Discuss your panel requirement

Send your single-line diagram, BOQ or tender reference. An engineer replies within one working day.

Have drawings or a tender? Use the full enquiry form.